Sea-doo 2005 3D RFI Instrukcja Użytkownika Pobierz pdf

Date: Septembre 27, 2005 Subject: Storage Procedure for 2-Stroke

Engine Equipped Vehicles

No. 2005-11

REVISION => 1: NOVEMB ER 3, 2005

YEAR MODEL MODEL NUMBER SERIAL NUMBER

3D™ RFI

2005

GTI™/GTIRFI/GTILE

All All

NOTE: Refer to a ppropriate Sea-Doo SHOP

MANUAL wh

en servicing a Sea-Doo watercraft.

ENGINE DR

AINING

Model(s): GTI 717

Check eng

ine drain hose [1] (lowest hose of

engine). Make sure there is no sand or other

particles in it and that it is not obstructed

so that water can exit the engine. Clean

hose and fitting as necessary.

CAUTION: Water in engine drain hose must

be free to flow out, otherwise water could

be trapped in engine. Should water freeze

in engine, severe damage will occur. Check

engine drain hose for obstructions.

F07E0MA

Printed in Canada. (sbs2005-012 PM) INTERNATIONAL 1 /9

®™ and the BRP logo are trademarks of Bombardier Recreational Products Inc. or its affiliates.

* Trademark of Bombardier Inc. used under license.

1 2 3 4 5 6 7 8 9

Podsumowanie treści

Strona 1 - ENGINE DR

Date: Septembre 27, 2005 Subject: Storage Procedure for 2-StrokeEngine Equipped VehiclesNo. 2005-11REVISION => 1: NOVEMB ER 3, 2005YEAR MODEL MODEL

Strona 2

Model(s): GTI LE / GTI RFIDisconnect the water supply hose used tocool the magneto. It features a quick connectfitting. Press both tabs [1] and pull f

Strona 3 - FUEL SYSTEM

PROPULSION SYSTEMJet PumpLubricant in impeller s haft reservoir shouldbe drained. Reservoir should be cleaned andrefilled with SEA-DOO synthetic 75W90

Strona 4

CAUTION: Fuel stabilizer should be addedprior to engine lubrication to ensure fuelsystem components protection againstvarnish deposits.WARNINGFuel is

Strona 5

CAUTION: Use only undiluted antifreeze (100%concentration). The pre-mixed antifreezeavailable from Bombardier RecreationalProducts Inc. is not suitabl

Strona 6

On vehicles equipped with 717 engine,Install a hose pincher on injection hose[1] going to tuned pipe.F17E03A1Photo shows engine water outlet hose [1],

Strona 7

Model(s): 787 RFI EnginesDisconnect hose [2] just above T-fitting[1] as shown.F15E02A21Install a hose pincher [1] just below T-fitting.Pour approximat

Strona 8

Disconnect water supply hose [1].Pinch water outlet hose [2].Install a temporary hose to engine fitting [3].F22E04A123Insert a funnel into the tempora

Strona 9 - CHECK LIST

NOTE: For the above engine and exhaustsystem procedures, although antifreeze willmainly drain out, it has mixed with the waterthat was possibly trappe